L. G. B. Mogul Instruction Manual - page 15
15
129 = control via button 1
(On only when moving forward)
CV52
Command for front light terminal
[128]
(see CV 51)
CV53
command for rear light terminal
[64]
(see CV51)
CV54
Hand-off function and “Back-EMF”
(0..3)
[2]
0 = hand-off function off, Back-EMF off
1 = hand-off function on, Back-EMF off
2 = hand-off function off, Back-EMF on
3 = hand-off function on, Back-EMF on
Hand-off function on: When operating
with 55015, you can adjust direction and
speed for two seconds after selecting
a moving loco without causing the loco
to stop.
CV55
Reset of most programmed CVs
55 = most important CVs are reset to
the factory pre-set values
CV60
Back-EMF: Max. adjustment factor
(1..255)
[48]
(0: small, 255: large)
Specifies the max. increase or decrease
of voltage applied during each time
interval (programmed in CV61)
Attention! The factory pre-set values of
CV60 and CV61 are optimized for
LGB motors.
CV61
Back-EMF: Adjustment frequency
(0..255)
[0]
(0: often, 255: seldom)
Specifies how often per second the
motor voltage is adjusted - accordingly,
the loco will react to curves and grades
immediately or with a short delay
CV62
Back-EMF: Max. Adjustment
(0..255)
[255]
(0: small, 255: max.)
Limits the total adjustment in motor
voltage. If there is a very large load on
the motor, the adjustment will not exceed
this value - for more realistic operations,
so that locos will slow a bit on grades.
CV67
Speed steps programmed by user
(0..255)
(see CV29):
to
28 speed steps are programmed in
CV67 to CV94.
CV94
With LGB MTS, every second value is
skipped (14 speed steps).
Factory pre-set speed steps:
7, 9, 11, 13, 16, 20, 24, 28, 32, 36, 42,
48, 54, 60, 68, 76, 84, 92, 102, 112, 124,
136, 152, 168, 188, 208, 230, 255
Pre-set values for user-programmable
speed steps:
8, 16, 24, 32, 40, 48, 56, 64, 72, 80, 88,
96, 104, 112, 120, 128, 136, 144, 152,
160, 168, 176, 184, 192, 208, 224,
240, 255
Hint: The speed steps are factory pre-set
and programming is not necessary.
Use the 55045 MTS PC Decoder
Programming Module for programming.