L.L.Bean MISSION ENTERTAINMENT STAND Assembly Instructions Manual

Summary of MISSION ENTERTAINMENT STAND

  • Page 1

    Mission entertainment stand thank you for purchasing our mission entertainment stand. Assembly of this product requires a phillips screwdriver and a hammer. We found it helpful to have a second person assist with a couple of the steps. 7460 atf7081230

  • Page 2

    Step 1 read through these instructions thoroughly before you begin assembly. We have found this to be of great value when first assembling this product. Step 2 remove all parts and hardware from packing material. Wooden pieces should be placed on a non-abrasive surface (like the carton or carpet) to...

  • Page 3

    Step 6 stand unit upright. Insert hinge pin into each predrilled hole in front corner of bottom shelf and drop two washers over each pin step 7 mount magnet catch in predrilled holes in underside of shelf (d) using 1/2" #6 pan screws provided. (underside of shelf has groove to accept back panel.) st...

  • Page 4

    Step 9 attach door pulls by placing pulls through decorative plates, then through door, securing with 5/8” pan screws. Step 10 slide back panel (c) into place in groove in bottom assembly. Add shelf (d) to cabinet assembly by aligning groove in underside of shelf over back panel (c). Attach only the...

  • Page 5

    Step 12 - a second person is helpful here. Position right door so that predrilled hole in bottom edge of door (e) engages hinge pin and washers in right front corner of floor assembly (b) installed in step 7. Close both doors as fully as possible. Grasp door handles with one hand and pivot shelf (d)...

  • Page 6

    Step 15 insert the 4 shelf pins into the holes drilled in the insides of side assemblies (a) step 16 install removable shelf (g) into cabinet by placing the shelf onto the 4 shelf pins ensuring that they align with and drop into the grooves in removable shelf (g). Care dust as needed with soft cloth...