1. DL manuals
  2. La Cornue
  3. Ventilation Hood
  4. CornuFé
  5. Service Instructions Manual

La Cornue CornuFé Service Instructions Manual

Other manuals for CornuFé: Installation, Use And Maintenance Manual

Summary of CornuFé

  • Page 1

    Cornufé 44 dual fuel range service instructions f107150-01 this book contains many important safety messages. Always read and obey all safety messages. Installer:leave these instructions with the range important - save the installation instructions for the local electrical inspector’s use..

  • Page 2: Warning

    Warning if the information in this manual is not followed exactly, a fi re or explosion may result causing property damage, personal injury or death. Do not store or use gasoline or other fl ammable vapors and liquids in the vicinity of this or any other range. What to do if you smell gas do not try t...

  • Page 3

    3 servicing  warning  work safely where necessary disconnect from electricity and gas before starting. Check range is safe when you have finished. Sections diagnostics 5 servicing section 12 schematic diagram of the range 31 technical data 32.

  • Page 4: Servicing Notes

    4 servicing  warning  work safely where necessary disconnect from electricity and gas before starting. Check range is safe when you have finished. Servicing notes when servicing or replacing gas carrying components disconnect from gas before commencing operation and check range is gas sound after ...

  • Page 5

    5 servicing  warning  work safely where necessary disconnect from electricity and gas before starting. Check range is safe when you have finished. Checking the multifunction oven 6 checking the convection oven 8 checking the cooktop 10 diagnostics.

  • Page 6

    6 check result possible cause open the oven door and turn on the oven light light does not work light bulb failed (most likely cause) no power to range fault in power supply to switch faulty switch action remove the light bulb (see ‘servicing procedures’). Check the bulb resistance with a meter and ...

  • Page 7

    7 checking the multifunction oven.

  • Page 8: Checking The Convection Oven

    8 check result possible cause open the oven door and turn on the oven light light does not work light bulb failed (most likely cause) no power to range fault in power supply to switch faulty switch action remove the light bulb (see ‘servicing procedures’). Check the bulb resistance with a meter and ...

  • Page 9: Checking The Convection Oven

    9 checking the convection oven.

  • Page 10: Checking The Cooktop

    10 checking the cooktop range maintop ignition the maintop burners have spark ignition operated by a switch on each control valve. When any burner control knob is pressed in the spark generator module produces sparks at all the burners ignition electrodes. Problem check the ignition system makes spa...

  • Page 11: Checking The Cooktop

    11 checking the cooktop problem check the burner lights but the fl ame goes out when the control knob is released each burner gas control valve includes a thermoelectric solenoid fl ame safety valve (fsd) that is normally closed. There is a sensor probe mounted on each burner. To light a burner the us...

  • Page 12

    12 1 how to change an oven light bulb 13 2 how to move the range for servicing 13 3 to remove the cooktop 15 4 to remove the control panel 16 5 to remove an outer side panel 16 6 to remove an oven neon 16 7 to change oven light switch 17 8. To remove a thermostat 17 9 to change a multifunction oven ...

  • Page 13

    13 servicing  warning  work safely where necessary disconnect from electricity and gas before starting. Check range is safe when you have finished. 1 how to change an oven light bulb replacement bulb must be 15w 125-130v lamp, for ovens, heat resistant to 300°c (570°f). Turn off the power at the ci...

  • Page 14

    14 servicing  warning  work safely where necessary disconnect from electricity and gas before starting. Check range is safe when you have finished. A left rear roller, b right rear roller, c center roller fit the allen key tool to the center roller lowering mechanism (c in the fi g.). Lower the fro...

  • Page 15

    15 servicing  warning  work safely where necessary disconnect from electricity and gas before starting. Check range is safe when you have finished. 3 to remove the cooktop move the range away from the wall - see ‘how to move the range for servicing’. Remove cooktop grates and burner heads. Undo th...

  • Page 16

    16 servicing  warning  work safely where necessary disconnect from electricity and gas before starting. Check range is safe when you have finished. 4 to remove the control panel remove all the control knobs. Open both oven doors. Remove 3 fi xings on the top front and 3 fi xings on the control panel...

  • Page 17

    17 servicing  warning  work safely where necessary disconnect from electricity and gas before starting. Check range is safe when you have finished. 7 to change oven light switch remove control panel (see 2). Nb the old switch may be destroyed during removal. Remove switch button and old switch fro...

  • Page 18

    18 servicing  warning  work safely where necessary disconnect from electricity and gas before starting. Check range is safe when you have finished. Left hand multifunction oven from inside the oven remove the two screws holding the thermostat phial to the oven fan cover at the rear of the oven. Fe...

  • Page 19

    19 servicing  warning  work safely where necessary disconnect from electricity and gas before starting. Check range is safe when you have finished. 11 to remove a cooktop valve remove the cooktop and control panel, see 1 and 2. Unplug the fsd lead from the rear of the valve. Undo compression fi tti...

  • Page 20

    20 servicing  warning  work safely where necessary disconnect from electricity and gas before starting. Check range is safe when you have finished. Remove the nut holding the nut holding fsd probe to the burner mounting cross member. Fit the new fsd probe, plug into the back of the control valve r...

  • Page 21

    21 servicing  warning  work safely where necessary disconnect from electricity and gas before starting. Check range is safe when you have finished. 15 to remove a cooktop burner spark electrode remove the cooktop grate and burner head. Undo the large brass nut and remove the brass venturi. Lift up...

  • Page 22

    22 servicing  warning  work safely where necessary disconnect from electricity and gas before starting. Check range is safe when you have finished. 17 to adjust the oven door angle the oven doors are very heavy. Transit of the range can cause the oven doors to move so that they are not correctly a...

  • Page 23

    23 servicing  warning  work safely where necessary disconnect from electricity and gas before starting. Check range is safe when you have finished. 18 to change the oven outer door panel or door trim parts the door outer panel and all the trim parts are available as separate parts so that individu...

  • Page 24

    24 servicing  warning  work safely where necessary disconnect from electricity and gas before starting. Check range is safe when you have finished. 19 to remove an oven door door is very heavy - take care. Open the oven door. Loosen the two top hinge screws. Support the weight of the door and remo...

  • Page 25

    25 servicing  warning  work safely where necessary disconnect from electricity and gas before starting. Check range is safe when you have finished. 21 to remove the door latch remove the oven outer door panel as detailed in section 18. Remove the fi xings that secure the latch assembly to the inner...

  • Page 26

    26 servicing  warning  work safely where necessary disconnect from electricity and gas before starting. Check range is safe when you have finished. 24 to remove the cooktop spark generator pull the range forward to access the covers at the rear of the range; see the section ‘how to move the range ...

  • Page 27

    27 servicing  warning  work safely where necessary disconnect from electricity and gas before starting. Check range is safe when you have finished. 27 to replace an oven fan pull the range forward to access the cover boxes at the rear of the range, see the section ‘how to move the range for servic...

  • Page 28

    28 servicing  warning  work safely where necessary disconnect from electricity and gas before starting. Check range is safe when you have finished. 29 to remove the left hand multifunction oven bottom and top elements bottom element pull the range forward to access the rear of the range, see the s...

  • Page 29

    29 servicing  warning  work safely where necessary disconnect from electricity and gas before starting. Check range is safe when you have finished. 30 to change the cooling fan pull the range forward to access the rear of the range, see the section ‘how to move the range for servicing’. Remove the...

  • Page 30

    30 servicing  warning  work safely where necessary disconnect from electricity and gas before starting. Check range is safe when you have finished..

  • Page 31

    31 schematic diagram of the range caution: label all wires prior to disconnection when servicing controls. Wiring errors can cause improper and dangerous operation. Verify proper operation after servicing. Code description code description cfm cooling fan motor ofm oven fan motor igs ignition switch...

  • Page 32

    32 servicing  warning  work safely where necessary disconnect from electricity and gas before starting. Check range is safe when you have finished. Technical data this range is supplied set for natural gas. A conversion kit from natural gas to propane gas is included. Installer: please leave these...

  • Page 33

    33 servicing  warning  work safely where necessary disconnect from electricity and gas before starting. Check range is safe when you have finished. Ovens left hand multifunction oven right hand convection oven fan element 2500w 2500w top element 1200w browning element 1150w bottom element 1000w ma...

  • Page 36

    060106.