La Crosse 513-1211.513-1211A Instruction Manual - page 3
Model: 513-1211/513-1211A www.lacrossetechnology.com/support Page | 3
Alarm
Bell Icon
Snooze
Icon
ACTIVATE/DEACTIVATE TIME ALARM
Press the SET button once to view alarm time.
Press the WAVE/+ or DST/- buttons to activate the alarm.
Once activated, the bell icon appears.
Press the WAVE/+ or DST/- buttons to deactivate the alarm.
The bell icon will disappear.
SNOOZE (SILENCES ALARM TEMPORARILY)
When alarm sounds, press the SNOOZE button to silence the alarm
for 5 minutes. The alarm icon will flash.
In snooze mode, press any button to stop alarm for one day.
Note: The alarm will sound for 2 minutes and then shut off completely.
MANUAL WWVB RADIO-CONTROLLED (ATOMIC) TIME SEARCH
Press the WAVE/+ button to start or stop a manual signal search. WWVB
Icon will flash when searching.
For information about WWVB visit:
www.nist.gov/pml/div688/grp40/wwvb.cfm
ATOMIC SIGNAL SEARCH: The clock will search every 2 hours until the WWVB
time signal is received. After reception, this clock will only search for the atomic
signal after midnight.
ATOMIC CLOCK CARE AND MAINTENANCE
Do not mix old and new batteries
Do not mix Alkaline, Standard, Lithium or Rechargeable Batteries
Always purchase the correct size and grade of battery most suitable for
intended use.
Replace all batteries of a set at the same time.
Clean the battery contacts and also those of the device prior to battery
installation.
Ensure the batteries are installed with correct polarity (+and -).
Remove batteries from equipment which is not to be used for an extended
period.
Remove expired batteries promptly.
SPECIFICATIONS
Temperature Range: +14 to +122 °F (-10 to +50 °C)
Power: 3-AA, IEC, LR6 batteries (not included)
Dimensions: 10.75" x 1.38" x 16.75" (273.05 x 30.052 x 425.45 mm)
LOW BATTERY ICONS
When the icon is displayed, replace batteries in the clock.
WWVB
Atomic Icon
Low Battery
Icon