La Crosse S88907 User Manual - page 8
La Crosse Technology, Ltd. www.lacrossetechnology.com/support
Page 8
Avoid transmitting antennas: (ham radios, emergency dispatch centers, airports,
military bases, etc.)
Electrical wires (utilities, cable, etc.)
Vegetation is full of moisture and reduces signal.
It is difficult for RF (radio frequency) signal to travel through a hill.
Temperature Alerts
Explanation: The remote and indoor temperature alerts are set in two separate steps.
Set the alert value.
Arm/Disarm the alert.
Select Temperature Alert Values:
Hold the ALERT button for five seconds to select and set temperature alert values.
1. REMOTE HI alert will flash. Press the ▲ or ▼ buttons to set the alert value, and press
the ALERT button to confirm. Then press the ALERT button again switch to REMOTE LO
setting.
2. REMOTE LO alert will flash. Press the ▲ or ▼ buttons to set the alert value, and press
the ALERT button to confirm. Then press the ALERT button again switch to INDOOR HI
setting.
3. INDOOR HI alert will flash. Press the ▲ or ▼ buttons to set the value, and press the
ALERT button to confirm and switch to INDOOR LO.
4. INDOOR LO alert will flash. Press the ▲ or ▼ buttons to set the alert value, and press
the ALERT button to confirm. Then press the ALERT button again confirm and exit.
Note: After selecting temperature alert values, use the next step to arm or disarm
individual alerts.
Temperature Alerts ON/OFF
In normal mode, press the ALERT button to toggle between:
Remote HI
Remote LO
Indoor HI
Indoor LO
Press the
▲ button to arm the selected alert.
The alert icon (bell) appears next to the alert, when the alert is active.
Press the
▼ button to disarm the selected alert.
Note: When no temperature alerts are set, the Temperature Alert area will show OFF.
Temperature Alert Sounds
When temperature alert sounds, the corresponding alert icon (bell) will flash.
The alert beeps once every minute, until the temperature is out of alert range.
Press any button to stop alert. The alert symbol will still show.
Turn alert OFF: In normal mode, press the ALERT button to select the alert. With HI or
LO alert selected, press the ▼ button to disarm that alert.
Weather Station
Power Requirements
This weather station is powered by a 5 volt AC power adapter
Alternatively, optional 3-AAA Alkaline batteries may be used.
12-Hour or 24-Hour time format
Time can display in 12-hour (am, pm) or 24-hour format.
Default is 12-hour time.
Use the
Program Menu
to switch time formats.