La Crosse Technology 327-1414Wv2 Instructional Manual - Position Wind Sensor

Page | 11                

www.lacrossetechnology.com/support/

              327-1414Wv2

• For the most accurate wind speed readings, mount the TX141W 

   sensor as the highest object for 50 feet in all directions. 

• Cups should be on the top of the sensor. Mount vertically.

• The maximum wireless transmission range to the wind station is 

   over 300 feet (91 meters) in open air, not including walls or trees.

1. Insert mounting pole into sensor.

2. Tighten screws

3. Insert bottom of pole into mounting bracket

4. Tighten knob to secure

5. Use screws through the bottom of the

    mounting bracket to attach.

6. The sensor can be mounted from 

    the bottom or side. (the picture is 

    of the sensor mounted from the side)

Alternatively:

1. Insert your own mounting pole into 

    the sensor.

2. Tighten screws

3. Mounting bracket would not be used.

Note: Do not attempt to insert a pole into the hollow back of the 

mounting bracket.  

Position Wind Sensor

• Mount the TX141TH-BCH add-on sensor on a north-facing wall or in 

   any well shaded area. Under an eave or deck rail is preferred. 

• The maximum wireless transmission range to the weather station is 

   over 300 feet (91 meters) in open air, not including walls or floors.

• Be sure the sensor is mounted vertically

Option 1:

• Install one mounting screw into a wall leaving some extended.

• Place the transmitter onto the screw.

• Gently pull the transmitter down to lock the screw into place. 

Option 2:   

• Insert the mounting screw through the front of the transmitter and 

   into the wall. 

• Tighten the screw to snug (do not over tighten).

Position Add-on Sensors