La Crosse WS-6010U Quick Setup Manual - page 6
6
Please help in the preservation of the environment and return used batteries to an
authorized depot.
SETUP AFTER CHANGING/REPLACING THE BATTERY IN THE SOLAR STATION
1.
After powering up the Solar Station, all LCD segments will light up briefly and it will show
the time (12:00), indoor temperature, date, and indoor humidity.
2.
After the batteries are inserted, the Solar Station will start receiving data signal from the
solar transmitter. The outdoor temperature and humidity data should then be displayed on
the solar station. If this does not happen after 2 minutes, the batteries will need to be
removed from both units and reset from step 1.
3.
The distance between the Solar Station and the transmitter should not be more than 200
feet (60.96m) to ensure sufficient 915 MHz transmission. (see notes on “Positioning” and
“915 MHz Reception”).
Note: When changing the batteries:
1.
Be careful that they do not spring free from the contacts.
2.
Press any button 20 times with the batteries removed.
3.
Always wait at least 10 minutes after removing batteries before re-inserting; otherwise
start up problems may occur.
TO SET THE TIME
Note: The time will be displayed with “AM” or “PM” for the time from 12:00 noon until 11:59.
1.
Press and hold the SET key for 3 seconds to enter the time setting mode.
Rechargeable Alkaline
battery switch position
Primary Alkaline
battery switch position