La Crosse WS9008UIT Manual - page 4
4
SETTING UP:
NOTE: The Temperature Station will receive one outdoor transmitter only.
1.
First, insert the batteries into the Temperature transmitter. (see “Install and
replace batteries in the Temperature transmitter“).
2.
Immediately after and within 1 minute, insert the batteries into Temperature
Station (see “Install and replace batteries in the Temperature Station”).
Once the batteries are in place, all segments of the LCD will light up briefly.
Then the indoor temperature will be displayed. If this is not displayed after 60
seconds, remove the batteries and wait for at least 10 seconds before
reinserting them.
3.
After inserting the batteries into the transmitter, the Temperature Station will
start receiving data from the transmitter. The outdoor temperature and the signal
reception icon should then be displayed on the Temperature Station. If this does
not happen after 3 minutes, the batteries will need to be removed from both
units and reset from step 1.
4.
In order to ensure sufficient 915 MHz transmission however, this should under
good conditions be a distance no more than 80 metres between the final
position of the Temperature Station and the transmitter (see notes on
“Mounting” and “915 MHz Reception”).