LAB:ONE ReQ·131 Instruction Manual - page 8
Page
8
ReQ·131 Instruction Manual
v1.2
How to connect audio
To connect the ReQ·131 you can use Reason’s own auto-connection system, and the ReQ·131 will
decide the best way to auto-wire; if you have a mono-output device (Subtractor, for example), and you
wish to add a ReQ·131 to it, the ReQ·131 will auto-connect the Subtractor output to the Left input, and
then continue to route the Left output of the ReQ·131 to the Left input of the mix-channel (or next
device in your processing chain).
You can do any of the following to create the ReQ·131;
a) right-click (Win) / CTRL-click (Mac) on the device, select ‘Create Device’, choose sub-menu ‘Studio
Effects’, and select ‘ReQ·131 (31 Band EQ)’ from the listing.
b) with the device selected, use the ‘Create’, select ‘Create Device’, choose sub-menu ‘Studio Effects’
and select ‘ReQ·131 (31 Band EQ)’ from the listing
c) using the Tool Palette in Reason (F8), select ‘Studio Effects’ when in the ‘Devices’ tab, and locate
the ‘ReQ·131 (31 Band EQ)’ device, click on the icon and drag it to the device you wish to add it to.
How to connect CV cables and sockets
To connect the ReQ·131 CV sockets, you require a source CV signal, which could be from a synth
module or effect module within Reason. Only information from a CV output on the source device can
connect to the CV inputs on the ReQ·131.
To connect the source CV out to any of the CV inputs of the ReQ·131 simply click-hold with your
mouse on the CV out socket of your source device and drag the yellow cable to the CV input of your
choice.
See page 15 for more information on how to use CV controls.
NOTE: CV cable configurations can only be saved and re-loaded within a Combinator device or a Mix
Channel / Audio Channel Combinator unit. Also, any Combinator patches using ReQ·131 with external
routings (ie a CV input from a device outside of the Combinator) will not recall the correct configuration.
Song files however will remember CV connections and CV knob settings.