Hd2-mx4x4-70k 4k hdmi 4 way matrix kit with hdmi output & hdbaset output over cat5e/cat6 user guide v2.2 v2.0
General safety ...................................................................................................................................................................................................2 introduction ..............................................................................
General safety ...................................................................................................................................................................................................2 introduction ..............................................................................
3. Output/input: press the output and input button to select the required output and corresponding input. For example: press ouput all>input 1, all outputs a,b,c,d will be set to input 1. Press ptp button, outputs a,b,c,d will correspond to inputs 1,2,3,4. 4. Edid: smart edid management, the lcm wil...
Back panel 1. Gnd: is used to earth the housing. 2. Ir matrix, ir ext: if ir sensor on the front panel is obstructed or the unit is installed in an enclosed area out of infrared line of sight, one of the ir rx receivers supplied can be connected to the ir ext socket on the back panel to extend the i...
As well as hd distribution you can also control the matrix and source devices from display locations using the ir back channel function. As the ir channels are two-way the displays can also be controlled from the matrix location. This is accomplished by placing a series of ir emitters on devices you...
Ir control system (ir back channel to matrix and source devices) 1. Power: led indicates receiver is powered. 2. Dc 24v: alternative power supply socket should not be required as receiver is powered by poe from the matrix. 3. Hdbaset in : standard hdbaset signal input port. Connect hdbaset transmitt...
1. Connect up to 4 sources such as blu-ray players, games consoles, cable or satellite receivers, pvrs etc. To the hdmi inputs on the unit. Do not hotplug! Connect and disconnect cables carefully with the power switch off. Connecting and disconnecting while the unit is powered can result in damage t...
9 ir all output port using an ir emitter connected to the ir all output port and ir receivers connected to the hdbt receivers you can control a source device (e.G. Dvd) from any of the connected displays using the source device remote. Global ir function ir all input port using an ir receiver connec...
10 bidirectional rs232 control function in example 2 below, the pcs or control systems connected to the receiver sends rs-232 signals to control other hdmi matrixes. The matrix system provides 4 channels with rs232 pass through functions, which can be used to control attached equipment. In example 1...
Waste electrical and electronic products should not be disposed of with household waste. Please recycle where facilities exist. Check with your local authority for recycling advice. If you experience problems setting up your matrix or have any other queries, please call the labgear customer care lin...
© labgear 2017. V1 www.Labgear.Co.Uk.
