Labgear HD2-MX4X4-70K User manual - page 7
IR Control system
(IR Back channel to Matrix and Source Devices)
1.
POWER:
LED indicates receiver is powered.
2.
DC 24V:
Alternative power supply socket should not be required as receiver is powered by PoE from the matrix.
3.
HDBaseT IN
: Standard HDBaseT signal input port. Connect HDBaseT transmitter with a UTP cable.
4.
HDMI OUT
: HDMI output port. This slot is where you connect the HDTV or monitor with HDMI cable.
5.
IR IN
: Channel 1 IR Receiver. Connect with Wideband IR Rx.
6.
IR OUT
: Channel 2 IR Transmitter. Connect with Wideband IR Tx.
7.
RS232
: Phoenix jack provides Serial port control signal from a receiver or to a receiver.
8.
Connection Signal Indicator LED
:
On (continuously): Transmitter and Receiver have a stable/good connection.
Flashing: Transmitter and Receiver have a poor connection.
Off: Transmitter and Receiver are not connected.
9.
Data Signal Indicator LED
On: HDMI signal data and HDCP data is being received.
Flashing: The HDMI signal data only is being received.
Off: No HDMI signal data is being received.
HDBT Receiver
➋
➌
➍
➎
➏
➐
➇
➈
➀
7