Laboga Mr.Hector User manual - page 10
10
14. Bright
High frequency boost for the distorted
channel.
HINT: Apart from the high frequency
boost, this switch also changes the
distortion character. It is possible that
using certain controls of equalizer or
gain, high frequency boost will be less
noticeable.
15. Clean gain
Amount of gain for the clean channel.
HINT: At a low setting of this
potentiometer, you get a clean sound.
When you boost clean gain, you get
sound more saturated
until crunch is
achieved. When you turn the Master
down and boost Clean gain, you obtain
crunch.
So you can get crunch on both
channels, which, at the same time,
differ in character and dynamics.
16. Bright
High frequency boost for the clean
channel.
HINT: use it to achieve clear sound. It
is helpful when pick-ups in the guitar
do not have enough high frequencies.
17. High input
High level input socket with high input
impedance.
HINT: This input is adjusted for guitars
with “passive electronics” - guitars
without preamplifiers.
18. Low input
Low level input socket.
HINT: This input is for guitars with
“active electronics” - guitars with
preamplifiers (most often they use
batteries built in the guitar)
It can also be used if the output signal
from pick-ups is very strong and if it is
impossible to get a clean sound on the
clean channel.