Laboga Mr.Hector User manual - page 11
REAR PANEL, VARIOUS FUNCTIONS
1. Power output socket for the 16 ohm
impedance cabinet.
2. Power output socket for the 8 ohm
impedance cabinet, or two 16 ohm
cabinets each and connected to both 8
ohm sockets.
HINT: Both outputs are connected in a
parallel way, that is why there is no
difference which output is used.
3. Power output socket for the 4 ohm
impedance cabinet, or two 8 ohm
cabinets each and connected to both 4
ohm sockets.
HINT: Both outputs are connected in a
parallel way, that is why there is no
difference which output is used.
ATTENTION! Do not connect
cabinets with different
impedances at the same time.
ATTENTION! Before turning
the amplifier on, make sure
the cabinet is connected to the
appropriate power output
socket.
11
4. Effects loop socket - “Send”
Output signal socket taken from the
preamplifier. Nominal signal output
level is 0dBV.
HINT: This output always has signal,
even if the loop is not used.
Consequently, the outlet can be used
to connect a guitar tuner permanently
– it does not influence the sound.
5. Effects loop socket – “Return”
Inserting a plug into this socket brakes
internal connection in the amplifier,
witch bypasses the effects loop.
HINT: This input can also be used as
line input, therefore the amplifier
serves as a power amp.
6. Balanced line output with guitar
speaker’s emulation
Balanced output with 0dBV line level,
where the signal is taken from speaker
transformer through guitar speaker
emulation.
HINT: Output can be used to connect
the amplifier directly to a mixer or
other devices.
ATTENTION! Do not use this
output without a speaker or
fake load connected to power
output socket.