Labomed Luxeo 6z User Manual - page 19
15
4146000-796
Issue 1.0
June 2016
Luxeo 6z
10
OBSERVATION & USE OF MICROSCOPE
Fig. 7
Fig. 8
Plug in the output of power adapter and connect the power adapter
to the AC
socket .
Press the power on switch (B).
The incident illumination (Ring Light) is controlled by the
switch (G) to glow all the 23 LED's, Eleven front LED's and
Twelve rear LED's. Press the button in the following sequence
to illuminate the LED's.
First press of button (G) to illuminate all the LED's in the ring.
Second press of button (G) to illuminate the rear twelve LED's
in arc.
Third press of button (G) to illuminate front eleven LED's in arc.
Fourth press of button (G) to switch off all the LED's.
Intensity control:
Press button (F) and (H) to increase or decrease the Ring light
intensity in six steps.
A
B
C
D
E
F
G
H
The incident illumination (Goose Neck LED) is controlled by the
switch
(D) to glow both sided Goose Neck LED's. Press the
button in the following sequence to illuminate the Goose Neck
LED.
10.1
Power on the microscope
10.2
Diopter setting of eyepieces
This adjustment should be performed every time the observer is
changed since the eyesight differs between individuals.
1. Turn the diopter rings on both eyepieces to set them at the 0
position (match the 0 line with the index line.
2. Turn the zooming knob to the highest magnification. Focus on
the sample using the focus knob.
3.
4.
Turn the zooming knob to the lowest magnification. Peering
through the left eyepiece with the left eye, focus on the sample
using the diopter ring on the left eyepiece. Then, peer through
the right eyepiece with your right eye and focus on the sample
using the diopter ring on the right eyepiece.
Repeat steps 2 and 3 until the image is kept focused even
though the zooming magnification is changed. This adjustment
ensures sharp image throughout the zooming range.
Fig. 9
Press button (D) to illuminate both Goose Neck LED.
Second press of button (D) to switch off Goose Neck LED.
Intensity Control:
Press button (C) and (E) to increase or decrease the Goose
Neck LED intensity in six steps.