LabRepCo LABH?14?SD Owner's Manual

Manual is about: general purpose

Summary of LABH?14?SD

  • Page 1

    General purpose refrigerators model: labh‐14‐sd, labh‐9‐sd, labh‐17‐sd, labh‐20‐sd, labh‐30‐sd, labh‐30‐hg, labh‐30‐hgc owner’s instructions this manual describes how to operate and care for your appliance to get the best, most efficient, performance. Read this book! Note to customer: this merchandi...

  • Page 2: Table Of Contents

    2 table of contents receiving .......................................................................................... 3 installation .................................................................................... 4 refrigerator operation .........................................................

  • Page 3

    3 receiving your unit was built, packaged, and inspected with extreme care. We shipped it to you using carriers we trust with a proven track record of careful handling, good customer service, and on time delivery. Unfortunately, regardless of all of these efforts sometimes accidents happen and occas...

  • Page 4

    4 installation uncrating – move your refrigerator as close to the final location as possible before unpacking. Remove the wooden planks or skid. The location should be as close as possible to the power outlet so the extension cord is not needed. This unit requires a minimum of 4 inches of air flow s...

  • Page 5

    5 shelf installation (not on all models) hook shelf clips onto pilaster strips (see illustration). Position all four shelf clips equal in distance from the floor for flat shelves. Wire shelves are oriented so that cross support bars are facing down. Place shelves on shelf clips making sure all corne...

  • Page 6

    6 refrigerator operation after the unit is properly installed and power is applied, it will take some time before the system is cooled down to temperature and cycling normally. You should wait 8 hours on the first startup before beginning to add product to the unit. This ensures that the unit is ins...

  • Page 7

    7 quick troubleshooting guide check these items before calling for service problem: possible cause / soultions: unit does not run  electrical circuit is not 110‐120v 60hz.  the power cord is not plugged in.  no power at electrical outlet. Check to make sure breaker is not tripped or fuse is not b...

  • Page 8

    8 moisture during the summer months the amount of moisture, condensation, or high humidity related issues increase during the summer and, in most cases, will self‐resolve when the weather cools down. Please note a refrigeration system will not generate moisture or water but simply condenses the mois...

  • Page 9

    9 maintenance and cleaning manual‐defrost units should be defrosted and cleaned whenever ¼ to ½ inch of frost has accumulated around the evaporator coils or if the unit will not maintain proper temperature. Use the procedures in the defrosting section at the bottom of this page auto defrost units re...

  • Page 10

    10 product warranty information horizon scientific, inc. Product warranty horizon scientific, inc. Warrants to the original purchaser every new horizon scientific, inc. Refrigerated unit, the cabinet and all parts thereof, to be free from defects in material or workmanship, when such unit is install...

  • Page 11

    11 horizon scientific, inc.’s maximum cumulative liability relative to all claims and liabilities, including obligations under any indemnity, whether or not insured, shall not exceed the cost of the product(s) giving rise to the claim or liability. Warranty is not transferable. This warranty is not ...