LabRepCo LABH?14?SD Owner's Manual - page 5
5
Shelf Installation (NOT ON ALL MODELS)
Hook shelf clips onto pilaster strips (see Illustration). Position all four shelf clips equal in
distance from the floor for flat shelves. Wire shelves are oriented so that cross support bars are
facing down.
Place shelves on shelf clips making sure all corners are seated properly.
Temperature control
NOTE: The control is preset at the factory to provide the desired air and product
temperatures inside of the unit and requires no further adjustment. Please contact the
manufacturer’s Technical Support Department before making any adjustments to determine
if adjustment is necessary and, if so, to make sure it is performed properly.
This unit has a manual thermostat located inside of the compartment. This thermostat controls
the compressor. Turning the thermostat towards the higher numbers will make the unit colder.
Lower numbers make it warmer. Turning the thermostat to the off or 0 position will turn the
unit off.