LaCie Ethernet Disk mini Manual - Getting Connected
user manual | page
Getting Connected
Step 2.1
–
Connect the power supply and switch on the drive.
There are two cables that are supplied with the power supply: one cable (A) connects to a power outlet,
such as a wall outlet or a surge protector; and the other cable (B) connects to the LaCie drive.
WARNING:
Use only the AC adapter supplied with your specific LaCie mini. Do not use a power supply
from another LaCie drive or another manufacturer. Using any other power cable or power supply may cause
damage to the device and void your warranty. Always remove the AC adapter before transporting your LaCie
drive. Failure to remove the adapter may result in damage to your drive and will void your warranty.
Important note:
You may use your LaCie mini when in a foreign country, thanks to its autoswitching
100-240 Volt power supply. To be able to use this feature, you may need to purchase an appropriate adapter
or cord. Consult LaCie Technical Support for assistance in choosing the right adapter. LaCie accepts no re-
sponsibility for any damage to the drive resulting from the use of an inappropriate adapter. Using an adapter
other than one authorized by LaCie will void your warranty.
2
3
4
1
Cable A
Power Supply Brick
Cable B
1
2
3
4
Connect Cable A to your LaCie mini.
Connect Cable B to the Power Supply brick.
Connect Cable B to a wall outlet.
Turn the drive on and off by using the On/Off switch.