Lafayette URANO User manual - page 23
21
3.9 AM/FM SYSTEM SETTING
There are AM/ FM two operating system in this radio.
Press [A/F] button to choose “AM” or “FM”.
The display shall show “AM” or “FM” icon.
NOTE: If the channel is AM (or FM) only, this button will be disable.
3.10 TRANSMITTING POWER
Press 3 seconds (or more) to select transmitting output power.
In FM mode: L=1W, H=4W; in AM mode: L=1W H=3W
Every press shall step to the next power level. And it will show “H” or “L” on the LCD display.
3.11 ROGER BEEP
This function is used to remind the partner, when the TX is off (PTT button is released), the radio
will beep to confirm to other users that your transmission has finished.
Press [F] + button to turn the ROGER BEEP tone on, the LCD will show
icon.
Press [F] + button to turn off this function, the LCD
icon will disappear.
3.12 DUAL WATCH (SCAN)
This function is used to scan the operating channel and “Priority Emergency Channel”.
•Press [P] button 3 seconds to set this function on, the LCD “d” and
icon will be on.
•The radio will be scanning between the operating channel and
“Priority Emergency Channel”.
•Press [P] button 3 seconds again to quit this mode, it will go to
the previous operating channel & the LCD “d” icon will be off.
Note
During this mode, the radio will stop at the channel that has sig-
nal. And when the signal disappears, it will go back to dual watch mode after 5 seconds.
During this mode, if PTT pressed, it will transmitting at that channel. And when [PTT] released,
it will go back to dual watch mode.
When [SQ] pressed, it will have noise from the speaker even if there is no signal.
During this mode, except [PTT] , [SQ] and [P], other buttons will be disable, and it will have
error sound when they are pressed.
3.13 MENU Function
This is multi function of system setting in this mode.
•Press [F] + buttons to enter into the setting menu, the LCD “M” icon will turn on.
•Press [F] + buttons to choose the desired setting item. There are three items could be set in
this menu. They are: SQ level, battery saving, beep tone.
•Then press or to do the setting and press [F] to store the setting and go to next setting item.
•Press any other button except or button , it will return to the operating mode without
storing the setting.