Lafayette ZEUS User Manual - English
ZEUS OPERATING INSTRUCTIONS
Having properly intalled and wired your CB and antenna and power supply, you are now
ready for the six steps designed to get you into effective and satisfactory operation.
Step 1: Screw the plug from the microphone into the microphone jack on the face panel and
check for secure fit.
Step 2: Make sure your antenna is securely connected to the antenna connector.
Step 3: Make sure the Squelch control is in the 9 o’clock position.
Step 4: Turn the power on and adjust the “volume” control for a satisfactory sound level.
Step 5: Select your desired channel by the channel selector up or down.
Step 6: To transmit, press the push-to-talk bar (PTT) on the microphone.
To receive, release the PTT bar.
OPERATING CONTROlS, CONNECTORS: FUNCTIONS AND USES.
DESCRIPTION
1 - FC (Function) button
Each button is separated for each function by double button.
In pressing FC button, FC is displayed on LCD and then BP/RB/SC/M1/M2/M3 button can
be used.
If you don’t press other button for 15 seconds after pressing function button, it is automatically
released and in pressing button again, it’s also released.
2 - AM/FM button (lCR button)
AM/FM functionSelect AM and FM type.
In pressing button, FM, AM is displayed on LCD and selected.
LCR function
It operates as LCR (Last Channel Recall) function in FM only.
3 - Tl/Rb (Tone low/Roger beep) button
Tone low (tl) function - In pressing button, TL is displayed on LCD and operated as
TONE LOw function.
Roger beep (rb) function - In pressing RB button after pressing FC button, RB is
displayed and becomes RB ON and ROGER TONE comes out after completion of
transmission. To release it, press FC button and press RB again and RB becomes OFF.
If letter disappear, it’s released. (It operates in FM only)
4 - SCh/bP (Sub channel/beep tone)
Sub channel(sch) function
SCH Call: In pressing button, SCH (Sub Channel) is displayed on LCD and press the
button again and MCH (Main Channel) is selected. It’s easy to select two channels
and convenient for operation.
*MCH is the existing used channel and SCH button is efficient enough to move to
Designated channel by pressing it just one time and if it is used with Sub watch (Sw),
it’s very convenient to operate two channels.
SCH SAVE: To save sub channel, press SCH button in SCH mode long and channel is
flashed on LCD and adjust channel by turning UP, DOwN Sw and press SCH button
again and it’s saved.
* when it is changed to SCH CHANNEL, other functions do not work.
a.
b.
a.
b.
1
a.