Laguna Revo 2036 Instruction Manual - page 14
Tool Rest Base (Banjo)
The Banjo is designed with cam-lock system. it can slide along the bed freely when
unlocked. Loosen the locking handle and move the Banjo to the desired place. Lock the
lever firmly after adjustment.
Tool Rest
A 14” tool support is provided with your lathe as standard. It is designed to allow
adjustment for height and angle. Loosen the locking lever to raise or lower the tool
rest and angle it to the work. Tighten the handle before operating the Lathe.
The locking lever can be inserted into one of three holes on the tool rest base.
Headstock, Tailstock
Both headstock and tailstock can slide along the bed. Loosen the locking lever and move
the Headstock or Tailstock to a desired place. Tighten the lever firmly after adjustment.
CAUTION
:
Always Unplug the lathe from the power source before headstock adjusting.
Spindle Centers installation/removing
1, Unplug the lathe from the power source.
2, Make sure the taper of center and the spindle taperred hole are clean and free of debris.
Then push the center into the spindle taperred hole for installation.
3, To remove the center, insert the knockout rod from back hole in end of spindle and tap
the center end (Fig. 15) out.
Fig. 15
Faceplate-Mounting and Removing
1, Unplug the lathe from the power source.
2, Mount the faceplate to the workpiece.
3, Install the face plate onto the spindle thread and turn it clockwise