Laipac S911 Lola Operation Manual - Laipac Technology Inc.
Laipac Technology Inc.
20 Mural Street, Unit 5, Richmond Hill Ontario L4B 1G5 Canada
Tel: 905-762-1228 | Fax: 905-763-1737 | E-mail:
info@laipac.com
|
http://www.laipac.com
47
1.
Introduction to LOLA’s working mode
According to the working status of LOLA’s major functional parts below
• Central controller
• GSM/GPRS communication channel (GSM/GPRS)
• GPS receiver (GPS)
• Motion sensor (G-sensor)
LOLA can be arranged to work at 3 different kinds of working mode below
• Normal Mode
• Stand-by Mode
• Sleep Mode
Table 1 shows the relation between working status of major functional parts and
Working Mode.
The principal intention aims to let LOLA’s user have more choice, according to his
application, to achieve longer battery time for Lola.
Working Mode
Major functional
Parts
Normal
Stand-by
Sleep
Central controller
Full speed
Full speed
idle
GSM/GPRS
Full functional or idle
Full functional or idle
Shut down
GPS
Full functional or idle
Shut down
Shut down
G-sensor
Moving Detection enabled
Impact Detection enabled
Moving detection enabled
Impact detection enabled
Impact detection enabled
Table 1
2.
Set up Working Mode
2.1
Set up Working Mode by using LocationNow Suite
Using Locationnow Suite utility software, user can set up LOLA’a working mode.
Refer to LOLA operation manual section
7.4.3
Special Function
2.2
Set up Working Mode on LocationNow V3 service platform
Through LocationNow-V3 service platform, LOLA’s user is able to change his
device’s working mode
• From Normal to Stand-by
• From Normal to Sleep
• From Stand-by to Normal
• From Stand-by to Sleep
Note: