Lake DIGI-TOOL F610 User Manual - page 15
15
THE AES/EBU INPUT
The input is situated on the back panel and
appears as a gold plated XLR female connec-
tor.
It is marked "DIG IN”.
The input is made according to AES 3/11-2003
specifications, transformer balanced, impedan-
ce 110 ohms, sensitivity 200 mV at Tnom/2.
A signal present at the "DIG IN” input is
displayed by the "MODULE INPUT ACTIVE”
LED on the frontpanel.
THE INPUT AMPLIFIER
The input signal is fed to a fast amplifier which
is capable to drive even weak signals to the
internal TTL level.
The signals are processed without alteration
of digital audio- or channel status data !!
THE SYNC OPTION
When the "SYNC OPTION” module is present,
a valid AES-Sync Signal, fed from the option
module, is always processed with priority. This
will be displayed by the "OPTION INPUT
ACTIVE” LED.
The absence of input signals – and for this
reason no output signal – is displayed by the
"NO INPUT SIGNAL” LED.
THE AES/EBU OUTPUTS
Four ouputs are situated on the back panel of
the case. They are denoted as "DIG OUT 1 / 2
/ 3 / 4” and equipped with gold plated XLR
male connectors.
The outputs offer appropriate drivers and meet
AES 3/11-2003 specifications, transformer ba-
lanced, impedance 110 ohms, output level > 4
Vss.
The slew rate is limited according to AES
specifications in principal, but 192 kHz
compatible.
AES/EBU SPLITTER MODULE
(if this Modul is present)