Lakeland 18923 Instruction Booklet - page 6
10
11
ELECTRICAL CONNECTIONS
THIS APPLIANCE MUST BE EARTHED
This appliance is fitted with a fused three-pin plug to BS1363 which is suitable for use
in all homes fitted with sockets to current specifications. If the fitted plug is not suitable
for your socket outlets, it should be cut off and carefully disposed of. To avoid an electric
shock, do not insert the discarded plug into a socket.
FITTING A NEW PLUG
If for any reason you need to fit a new plug, the flexible mains lead must be connected
as shown here. The wires in the mains lead fitted to this appliance are coloured in
accordance with the following code:
Connect BLUE to Neutral (N)
Connect GREEN/YELLOW to Earth (E)
Connect BROWN to Live (L)
13 amp fuse to be used
If the colours of the wires in the mains lead of this appliance do not correspond with the
coloured markings identifying the terminals in your plug, proceed as follows. The wire
which is coloured green and yellow MUST be connected to the terminal which is marked
with the letter E (Earth). The wire which is coloured blue MUST be connected to the
terminal which is marked with the letter N (Neutral). The wire which is coloured brown
MUST be connected to the terminal which is marked with the letter L (Live).
Before refitting the plug cover, check that there are no cut or stray strands of wire inside
the plug. Use a 3 amp BS1362 fuse. Only BSI or ASTA approved fuses should be used. If
you are at all unsure which plug or fuse to use, always refer to a qualified electrician.
Note:
After replacing or changing a fuse on a moulded plug which has a fuse cover, the
cover must be refitted to the plug; the appliance must not be used without a fuse cover.
If lost, replacement fuse covers can be obtained from an electrical shop. This appliance
complies with the following EU Directives: 2006/95/EC (Low Voltage Directive) and
2004/108/EC (EMC Directive).
RECYCLING YOUR ELECTRICALS
Along with many other high street retailers, Lakeland has joined a
scheme whereby customers can take their unwanted electricals to
recycling points set up around the country.
Visit
www.recycle-more.co.uk
to find your nearest recycling point.
CARE AND CLEANING
• Unplug the base unit and allow the Milk Frother to cool before cleaning.
• Before first use and after every use, clean each part thoroughly.
• Periodically check all parts before reassembly.
• Never immerse the jug or base in water or any other liquids.
• To clean the outside of the jug and the base, wipe with a clean, damp cloth and dry
before storing. Rinse the inside of the jug with hot soapy water, rinse with clean water
and dry thoroughly. Do not use hard or sharp objects to clean inside the jug, this will
damage the non-stick coating.
• To clean the whisk and holder, push the whisk out of the holder. Clean the lid,
whisk and holder with warm soapy water and a soft sponge or cloth. Rinse and dry
thoroughly.
• Do not use abrasive cleaners, bleaching agents or metal scourers on any parts. This will
damage the appliance.
• Do not put any parts of the Milk Frother in the dishwasher.
• Do not use metal spoons or other utensils with sharp edges to spoon milk or froth from
the appliance. These will scratch the coating inside. Pour only.
• Store the Milk Frother with the power cable loosely coiled. Never wrap it tightly around
the machine.