Lami Corporation Lotus-14LK-H Instruction Manual - page 10
9
Set the speed of laminate process.
Speed can be set in 6 steps using 【1】~【6】 buttons.
Press 【Stop】 button to stop rotation of the roller.
If 【Reverse】 button is pressed during rotation of the
roller, the roller rotates in reverse direction while the
button is being pressed.
※ Since the roller is damaged when stopped at high
temperature, stop in short time if possible. If stopping
time is increased, lift the up-down lever.
Speed setting, stop, and reverse buttons
Temperature setting button
『HOT』 button
『COLD』 button
『STANDBY』 button
Power is turned ON and
speed setting button 【4】
is pushed
Use this button to set specific temperature.
When 【INCREASE】 button is pushed, temperature setting
display on LCD increases. When 【DECREASE】 button is
pushed, temperature setting display on LCD decreases.
Temperature can be changed by 1℃ within the range of 1
70℃~190℃.
※ Set appropriate temperature depending on the type of
material being processed and laminate film.
When 【HOT】 is pushed, setting temperature is set to
180℃ and speed setting to 2. Change the value of
temperature setting with the buttons described above
depending on the paper to be processed.
Once surface temperature of the roller reaches the
setting, cooling fan begins to rotate and 【READY】 lamp
is turned on in the LCD screen.
When 【COLD】 button is pressed, setting temperature is
set to 0℃ and speed setting to 1.
FAN will automatically stop once temperature of the roller
reaches certain temperature.
When 【STANDBY】 button is pressed, setting temperature
is set to 80℃ and surface temperature of the roller is
maintained around 80℃.
Flickers
【DECREASE】 button is
pressed once from HOT
setting
【HOT】
button
is
pressed
for
temperature setting
【COLD】
button
is
pressed once for in
HOT setting
【STANDBY】
button
pressed in HOT setting
Flickers
Flickers
179
180