Lamona LAM1761 User's Installation Manual - page 17
_ 17
User manual LAM1761
05 - Troubleshooting
If you encounter a problem, it is often something minor, please read some of the suggested tips below.
Thehobproducesasmellthefirstfewtimes
it is used
This is normal - Heat a pan full of water on each zone for half an hour.
Pans make a noise during cooking!!
This is caused by vibration due to the passage of energy from the hob
to the pan. On a high setting this is quite normal for certain types of
saucepan. It will not damage the hob.
The hob makes a slight clicking sound
This is Normal - This is caused by the distribution of power between
two heating zones on the same side of the hob.
The fan keeps working for a few minutes after the hob has been
turned off
This is Normal - To cool down the electronics.
The hob won’t work. The indicators don’t come on
Theelectricitysupplyisnotreachingtheappliance(faultysupplyor
connection);Checkthefusesandthecut-outswitch.
Refer to Troubleshooting chart and if problems persist call, the
customer service hot-line for further assistance.
The hob has turned itself off
Check that the main on/off switch has not been touched or covered
accidentally, remove any objects on the hob and try turning it back
on again.
Repairs
Repairs are to be carried out by trained service technicians.
Error codes
Hob Status
Codes
Fault Description
Action
U
Indicates no pan or suitable pan on
cook zone
Ensure correct pan size and that the pan is suitable for induction use
(Checkwithamagnet)
H/C
Zone Over Temperature Product will
auto reset, Indicates pan overheat
Allow hob to cool
C/P
Heater Over Temperature Product will
auto reset, Pan overheat
Allow hob to cool
H/c
Induction Generator Over Temperature
Checkinstallationandfreeairflowtohob
H
Residual Heat
“H”willswitchoffwhenglasssurfacedropsbelow60ºC
Appliance Errors
& Alarms
Fault Description
Action
F0
Software Error
Switch the power off and on, The system will reset and the hob should
now be working correctly
FA
Software Key Error
Switch the power off and on,The system will reset and the hob should
now be working correctly
FC
Software Key Error
Switch the power off and on, The system will reset and the hob should
now be working correctly
FE
Touch Ntc Error
Switch the power off and on, The system will reset and the hob should
now be working correctly
Ft
Touch Ntc Error
Switch the power off and on, The system will reset and the hob should
now be working correctly
If any of the above problems persist please contact the customer service line for further assistance,
Troubleshooting