Lamona LAM1761 User's Installation Manual - page 20
20_
LAMONA
Appliances
Clearances and dimensions – requirements
•
No shelf or overhang of combustible material
should be closer than 650mm above the hob.
•
There must be a minimum clearance of 50mm
between the edges of the hob and any side
walls; this clearance must be maintained up to
420mm above the worktop.
•
When installing an extractor hood above the
hob, refer to its manufacturer’s instructions
Clearances and dimensions – requirements
•
There must be a minimum clearance of 50mm
between the rear edge of the hob and the rear
wall. This clearance must be maintained up to
650mmabovetheworktop(unlessotherwise
statedinyourextractormanual)
560mm
50mm Min
50mm min
420mm min
490mm
Minimum distance
between carcasses must
be equal to width of hob
*
Minimum height to extractor
as recommend in extractor
instruction manual
*
50mm min between hob and rear wall
(>60mm to cut out aperture)
Fitting into worktop
Cut a hole in the work surface to the required size.
(560mmx490mm)asillustratedabove.
A clearance of at least 50mm should be maintained
between the cutout and any rear or side wall.
The worktop must be of heat-resistant material or
covered with heat-resistant material.
Protecting the cut-out
The types of chipboard used for work
surfaces swell relatively quickly in contact with
humidity.
Apply a suitable sealant to the cut edge to protect it
from moisture ingress.
Self Adhesive Seal
Apply the self adhesive seal to the underside edges
of the hob glass. For best results, the seal should
be adhered along each side in turn, as close to
the edge as possible, and trimmed at each corner,
taking care to ensure a neat join.
This hob can be installed conventionally
(glassabovetheworktop)orrecessedintothework
topforaflushfit..
Conventional installation
Place the hob in the aperture, checking the hob
glass is covering the work top along all four sides.
Set the front edge of the appliance parallel with the
front of the work top.
Remove 4 x self tapping screws from the appliance
locate and attach the securing clamps as required,
Tighten the screws so that the hob is pulled down
firmlyagainsttheworktop,thusensuringagood
seal.
Recessed method
Recess the work top to the appropriate depth
(Approx5mm)andshapetofitthehob(add1mmto
overall glass size.
Insert the hob into the recess, ensuring that the
foam seal is sitting correctly.
Remove 4 x self tapping screws from the appliance
locate and attach the securing clamps as required,
Tighten the screws so that the hob is pulled down
firmlyagainsttheworktop,thusensuringagood
seal.
Youmaywanttofillanygapbetweenthehobtop
glass and the work top surface with silicone sealant.
Installation