Lamona LAM1763 User's Installation Manual - page 15
_ 15
User manual LAM1763
05 - Troubleshooting
If you encounter a problem, it is often something minor, please read some of the suggested tips below.
Thehobproducesasmellthefirstfewtimes
it is used
This is normal - Heat a pan full of water on each zone for half an hour.
Pans make a noise during cooking!!
This is caused by vibration due to the passage of energy from the hob
to the pan. On a high setting this is quite normal for certain types of
saucepan. It will not damage the hob.
The hob makes a slight clicking sound
ThisisNormal-Thisiscausedbythedistributionofpowerbetween
two heating zones on the same side of the hob.
The fan keeps working for a few minutes after the hob has been
turned off
ThisisNormal-Tocooldowntheelectronics.
The hob won’t work. The indicators don’t come on
The electricity supply is not reaching the appliance (faulty supply or
connection); Check the fuses and the cut-out switch.
Refer to Troubleshooting chart and if problems persist call, the
customer service hot-line for further assistance.
The hob has turned itself off
Check that the main on/off switch has not been touched or covered
accidentally, remove any objects on the hob and try turning it back
on again.
Repairs
Repairs are to be carried out by trained service technicians.
Error codes
Appliance Errors
Fault Description
Action
ER03 and
permanent tone
Continuous button actuation;
control switches off after 10 s
Clean the user interface.
E2
Over temperature
Allow system to cool
E3
1. Pot/pan not suitable, example
Loss of magnetic properties
because of temperature at bottom
of pot.
2. Power of cooking zones
permanently exceeded
1. This error is reset after 30 s; the cooking zones can
be used again. The pot/pan must be removed if the fault
keeps reoccurring.
2. The power unit must be replaced if the error
continues to be displayed even when no pot/pan is
present on the cooking zone.
E/H
Invariable resistor fault
Induction module must be cool
Troubleshooting