- DL manuals
- Lamona
- Ventilation Hood
- LAM2100
- User Manual
Lamona LAM2100 User Manual
Summary of LAM2100
Page 1
User guide lam2100 60cm conventional extractor www.Howdens.Com/appliance-registration.
Page 2
See back page for product serial number.
Page 3
Page _ 3 dear customer, congratulations on your choice of domestic appliance. The user manual will help you use your product quickly and safely. • please read this user manual before installing and using the oven. • always follow the safety instructions. • keep this user manual within easy reach for...
Page 4
Exclusive to howdens joinery.Co page _ 4 index before using the extractor 05 safety 05 general 05 fire safety 07 safety for children 07 7 0 y ti c ir t c e l e h ti w g n i k r o w n e h w y t e f a s general information & operation 08 t u o y a l r o t c a rt x e 08 control panel layout 08 using yo...
Page 5
Www.Howdens.Com page _ 5 • make sure that you have removed all packaging, wrappings, stickers and from the extractor • it is recommended that you clean the extractor’s surface before using for the time. Before using the extractor this appliance is for domestic extraction purposes only. It must not b...
Page 6
Www.Howdens.Com page _ 6 important safety information • • • • • • • • • • • • • • • • • please dispose of the packing material carefully – children are especially vulnerable to it. If the room where the extractor is to be used contains a fuel burning appliance such as a central heating boiler then i...
Page 7
Exclusive to howdens joinery.Co page _ 7 • when the hood is being used in extraction mode, ensure that the ducting is retardant and that there are no bends greater than 90 degrees as this will reduce the of the hood. • ensure the ducting for the extractor mode has the same diameter as the outlet hol...
Page 8
Www.Howdens.Com page _ 8 general information & operation control panel layout extractor layout vent recirculation extractor off low speed medium speed high speed light select lever position related to the type of install. For vented operation charcoal filters are not used..
Page 9
Exclusive to howdens joinery.Co page _ 9 using your cooker hood to use your cooker hood light on/off slider 0 = light off 1 =light on speed control slider 1. Off 2. Low speed 3. Medium speed ideally caution - accessible parts may become hot when used with cooking appliances. You should turn on your ...
Page 10
Www.Howdens.Com page _ 10 before cleaning or attempting any type of maintenance, always make sure that the electricity supply is disconnected. The manufacturer declines all liability in cases where the instructions for the appropriate installation, maintenance and use of the extractor hood are not o...
Page 11
Www.Howdens.Com page _ 11 care and maintenance the carbon filters if the appliance is going to be used in recirculation mode when it is necessary to fit carbon filters. This will help absorb odours caused by cooking. Carbon filters have a limited life. We advise you to change them when there is a no...
Page 12
Exclusive to howdens joinery.Co page _ 12 replacing the lamps the extractor hood is with lamps that may need to be replaced periodically. Lamp replacement is not covered by your guarantee the lamps on this appliance should only be used during operation of the cooker hood. They should not be left on ...
Page 13
Www.Howdens.Com page _ 13 methods of extraction the very best method of clearing the kitchen of unwanted odours is by connecting the appliance to an exhaust duct and venting to the outside atmosphere via the ceiling or an exterior wall. (suitable ducting kits may be purchased from the depot where yo...
Page 14
Exclusive to howdens joinery.Co page _ 14 before beginning installation • check that the p important : the cooker hood can be ducted from the rear or from the top. The following steps should be taken before fitting the appliance. If you want to connect the duct hose to the top of the cooker hood, th...
Page 15
Exclusive to howdens joinery.Co page _ 15 installation dimensions fittings 600mm (min) (minimum 650mm ( see page 7)) hob top x1 x1 x4 x4 x4 x8 x4.
Page 16
Www.Howdens.Com page _ 16 installing your cooker hood you will have to decide before installing your cooker hood whether to use it in extraction mode or recirculation mode. Cupboard mount cabinet base cabinet base w (using screws and bolts supplied) cut out for top vented installation e suggest the ...
Page 17
Exclusive to howdens joinery.Co page _ 17 installing your cooker hood • wall mounted • • • • • • remove the grease filters (see page 10) hold the hood against the wall in the intended position and mark position of the screw holes that are to be drilled. Using an 8mm diameter drill, drill holes in th...
Page 18
Exclusive to howdens joinery.Co page _ 18 fig 3. Fig 4. N l l n load supply load supply dp 250v~ fuse on blue. (neutral) brown. (live) green / yellow. (earth) electrical connections important: ensure that the electricity supply is switched off before connecting. Your appliance must be connected to w...
Page 19
Www.Howdens.Com page _ 19 troubleshooting guide symptoms possible cause solutions lamps fail to operate? • a replacement lamp is probably necessary, but check that the lamp is correctly into its holder. Disconnect the mains electricity supply before adjusting or replacing the lamps. The extractor la...
Page 20
Exclusive to howdens joinery.Co page _ 20 your guarantee product guarantee details (uk only) and serial number on your machine. Remove grease filters - sticker in the motor cavity area. Your appliance has the benefit of a comprehensive manufacturer’s guarantee which covers the cost of breakdown repa...
Page 21: Product Fiche
Model lam2100 aec 67 kwh/a f 1.6 fde hood 10.9% eei hood 94.8 q bep 80.1m3/h p bep 218 pa q max 150.1 m3/h w bep 44.7 w w l 56 53 w e middle lux p s - p o 0 lp wa 70 db product fiche commission regula on (eu) no 65/2014 * values stated on the product labels or in the documentation accompanying it ar...
Page 22
Product serial number (place sticker here) issue v1 021216.