Lamona LAM2100 User Manual - page 14
Exclusive to Howdens Joinery.co
Page _ 14
Before Beginning Installation
•
Check that the p
IMPORTANT
: The cooker hood can be ducted from the rear or from the top.
The following steps should be taken before fitting the appliance.
If you want to connect the duct hose to the top of the cooker hood, then you should place the cover
over the venting hole on top of the appliance.
If you want to connect the duct hose to the top of the cooker hood, then you should place the cover
over the venting hole on the rear of the appliance. Then fit the coupling to the venting hole on the top
of the appliance.
The maximum distance between the cooker hood and your discharge outlet should be 3 metres, with
one 90 degree bend. For each additional 90 degree bend, the maximum distance is reduced by a metre.
Rear Venting
Top Venting
Extractor Dimensions
roduct purchased is of a suitable size for the chosen installation area. In addition
check whether there is an electrical socket available that will be accessible once the hood is mounted.
If the product is going to be used in extraction mode, then there should also be space to connect a
ducting hose to the outside.
•
Carry out all necessary masonry work prior to the
of the cooker hood and cabinetry.
•
Ensure that all electrical connections are carried out by a suitably
person.
•
Check inside the product and ensure that there is no transit packaging or any other materials, such as
packets of screws, guarantees etc. These should be removed and kept for future use.
•
•
•
•
•
Protect any hob already installed below with a blanket or cardboard etc, to prevent possible damage.
82
120
600
05
1
500