Lamona LAM4602 User Manual - page 25
2.
Pull the rear end of the shelf support
away from the side wall and remove it.
1
2
Install the shelf supports in the opposite
sequence.
The retaining pins on the
telescopic runners must point to
the front.
Catalysis
CAUTION!
Do not clean the
catalytic surface with oven
sprays, abrasive cleaning
agents, soap or other cleaning
agents. This will damage the
catalytic surface.
Remove all accessories and removable
shelf supports.
The walls and the top of the cavity are
catalytic-coated. They absorb fat and food
particles at high temperature without smell.
To support this self-cleaning process heat
the appliance without any food regularly.
Spots or discolouration of the
catalytic surface have no effect
on catalytic properties.
During the catalytic cleaning the oven lamp
is on.
1.
Set the Cata cleaning function (refer to
"Oven functions"). The display shows
"Cata" and the duration of the cleaning
procedure (1 hour).
You cannot set the Duration, but you
can use the End function to delay the
start of the cleaning procedure.
An acoustic signal sounds after the time
ends. The appliance deactivates.
2.
Touch a sensor field or open the oven
door to stop the acoustic signal.
3.
Clean the bottom of the appliance with
a soft and moist sponge.
Removing and installing the
door
You can remove the door and the internal
glass panels to clean it. The number of
glass panels is different for different models.
WARNING!
Be careful when
you remove the door from the
appliance. The door is heavy.
1.
Open the door fully.
2.
Fully lift up the clamping levers (A) on
the two door hinges.
A
A
3.
Close the door until it is at an angle of
approximately 45°.
25