Lampo Supertracer 2500 HTI User Manual - page 5
4
NOISE LEVEL
After the projector has been powered up and the initial configuration takes place, the noise produced by the
projector is primarily due to its cooling system. The noise level is much lower than the limit of 70 db A permitted by
law.
PACKING
The projector is shipped and delivered in a cardboard box made of KRAFT cardboard and semi-chemical additive-
free paper, in compliance with BSFV Class 3 standards for waste disposal.
The projector is completely assembled, placed in the box inside a polyethylene bag and held firmly in place with
polyurethane foam packing material. The box is stapled shut.
Even though the packing provides complete protection from rain, it must not be exposed to inclement weather or
humidity.
No more than three identical boxes can be stacked one on top of the other.
Keep the original packing for possible shipments in the future.
STORAGE
The projector, in its original packing, must be kept in covered, dry areas with a temperature between –10°C and
+50°C.
HANDLING
The projector, with or without packing, must be handled with care.
Lifting and handling must be carried out with special equipment. Do not expose the projector, with or without its
packing, to brusque accelerated or decelerated movements, knocks, dragging, or other stress caused by
unsuitable handling.
The projector in its packing can be seriously damaged if it falls or suffers a blow during transportation.
HANDLE WITH CARE!
ADMISSIBLE ENVIRONMENTAL CONDITIONS
The projector was engineered and produced to function in covered dry areas with an air temperature ranging
between 0° and 35° C, and with a humidity level between 30 and 90%.
Sharp changes in room temperature may generate condensation inside the projector which can harm the projector.
Therefore, switch on the projector only after it has undergone a period of gradual adaptation to the room
temperature.