Lampociclo E bike User Manual - page 6
User guide rev 7 .doc - Page 6
LAMPOCICLO USER GUIDE
www.lampociclo.com info@lampociclo.com
Periodical maintenance
1.
Check the tyre pressure once a month. Note The Balloon tyre should be inflated at 3 – 4 bars
2.
Battery charge status: you can monitor bike charge status using a common bike trip computer or
GPS phone. However to extend battery life, avoid using the battery up to maximum discharge.for
example the battery could be recharged when approximately half of its mileage power has been
consumed.
3.
The chain tension should be slightly tightened after the first hundred kilometres (Q) leaving 2-3 cm
of play. After first tightening this, it should not be necessary to retighten for several years.
Extra maintenance
1.
Battery removal
1.1.
Open the side panel with Key (H)
1.2.
Remove the battery power outlet (I)
1.3.
Remove the battery charge inlet (L)
1.4.
Remove the elastic holder (M)
1.5.
Remove the battery by pulling strap (N)
2.
Fuse change: Open the cover (O) integrated to the plastic plug. A spare fuse is located within the same
cover.
3.
Rear wheel removal:
3.1.
remove the gear shifter (P)