LAN Power Systems LP2521 Installation And User Manual - Powering Up The Injector
Powering Up the Injector
2-3
Plug one end of the power cord into the Injector and the other end into a
grounded AC power source. Units are typically connected to a power
strip or other power outlet that may be cycled on and off. An
uniterruptible power supply (UPS) may be used. This assures
uninterrupted power to the End device should there be a loss of building
power.
Safety Instructions: The means of connection to the mains supply is the
detachable power cord of the equipment. The equipment disconnect
device is the appliance inlet. The AC socket outlet shall be installed near
the equipment and shall be easily accessible.
Next, attach a LAN data cable patch cord of minimum Cat5 cable grade
from the Ethernet Switch port to the RJ45 connector on PoE Injector
marked “IN”. Then attach a second patch cable from the “OUT” RJ45
connector on the PoE Injector to the structured wiring connection leading
to the device to be powered. Turn on power source. The “IN” LED on
the Injector will glow “GREEN”. If End device to be powered is already
installed on Network, the “OUT” LED will glow “GREEN”. The PoE
Injector is now correctly installed and operating.