Land Pride FM3188 Operator's Manual - Caution
18
Section 4: Maintenance & Lubrication
FM3188 & FM4188 Flail Mowers 309-523M
6/24/11
Table of Contents
Section 4: Maintenance & Lubrication
Maintenance
Proper servicing and adjustment is the key to the long life
of any implement. With careful inspection and routine
maintenance, you can avoid costly down time and repair.
Check all bolts after using the unit for several hours to be
sure they are tight. Replace any worn, damaged or
illegible safety labels by obtaining new labels from your
Land Pride Dealer.
The parts on your Flail Mower have been specially
designed and should only be replaced with genuine Land
Pride parts. Do not alter the mower in a way which will
adversely affects its performance.
!
CAUTION
For safety reasons, each maintenance operation must be
performed with tractor PTO disengaged, mower lowered
completely to ground and tractor engine shut off with ignition
key removed.
•
After using the mower for several hours, check all bolts
to be sure they are tight and check drive belt tension.
Refer to “Belt Tension Adjustment” on page 17.
•
Lubricate components as listed under “Lubrication” on
page 21.
•
Replace any worn, damaged or illegible safety labels by
obtaining new labels from your Land Pride Dealer.
Information about labels is located under “Safety Labels” on
page 4.
Trash Removal & Rotor Knife Access
Refer to Figure 4-1 & Figure 4-2:
The rotor knives and trash accumulated around them can
be accessed by opening the rear cover (#2).
1.
Unscrew cover locking handles (#1) located on both
sides.
2.
Raise rear cover (#2) up as shown.
3.
Replace locking handle in cover open location (#3) to
secure cover in the up position.
4.
Return cover to the closed position after servicing
rotor knives and cleaning out trash.
Rotor Knife Access (Shown With Cover Closed)
Figure 4-1
24870
1
2
3
Rotor Knife Access (Shown With Cover Open)
Figure 4-2
24985
1
3
2
1
3