Laney LC30-112 Operating Instructions Manual - page 12
L Z B 1 2 3 4
POWER INLET SOCKET: Connect to your power source. Make sure the specified voltage is correct for your country!
POWER FUSE: This drawer contains the main safety fuse for the unit. The fuse protects the AC power to the amplifier.
USE ONLY THE CORRECT SIZE AND RATING OF FUSE AS SPECIFIED ON THE PANEL. If a fuse blows or fails and a
replacement of the same size and rating is installed and it in turn blows, the amplifier has suffered a malfunction internally and
needs immediate service from a qualified technician. DO NOT TRY USING A FUSE OF HIGHER RATING. Using a fuse that
is too large in current rating may cause serious, irreparable damage to the amplifier and presents a serious fire hazard. The
mains fuse ratings are detailed in the specs section on page 7 of this manual
HT FUSE: This fuse protects the DC power to the tubes within the amplifier. USE ONLY THE CORRECT SIZE AND
RATING FUSE AS SPECIFIED ON THE PANEL. If a fuse blows or fails and a replacement of the same size and rating is
installed and it in turn blows, the amplifier has suffered a malfunction, at this point check the output tubes and replace faulty
ones if required. Should tubes not be the problem the amplifier should be checked out by a qualified technician. Do not try
using a fuse of greater value. Using a fuse that is too large in current rating may cause serious, irreparable damage to the
amplifier. Fuses are designed to protect, do not take chances.
SERIAL NO: Displays the model and serial number of the unit.
EFFECTS LOOP: SEND/LINE OUT: Connect the input of your external effect to this socket. All of the signal leaves the
amplifier via the `Send’ socket to be processed and comes back from the effects via the `Return` socket. This socket can also
be used to control another L
-112 amplifier connected to this socket via its own return socket. Some Effects are better
C30
1
2
3
4
5
REAR PANEL CONTROLS
1
2
3
4
5
6
7
8
9
10
11
Spare power fuse
included in the tray.