Laney R5 User Manual - page 12
Selects the LO MID-frequencies to be cut or boosted in
conjunction with the
LO PARAMID LEVEL control (7). To
access
low LO mid-frequencies turn the FREQUENCY control
anticlockwise, to access higher LO MID frequencies turn the
FREQUENCY control clockwise
Sets the level of boost or cut applied to the frequency set
by control 6.
For frequency-boost turn the control
clockwise.
For frequency-cut, turn the control anti-
clockwise
Hi Paramid Frequency : Selects the HI MID-frequencies to
be cut or boosted in conjunction with the Hi PARAMID LEVEL
control (9). To access
low Hi mid-frequencies turn the
FREQUENCY control anticlockwise, to access higher Hi MID
frequencies turn the FREQUENCY control clockwise
Sets the level of boost or cut applied to the frequency set
by control 8.
For frequency-boost turn the control
clockwise.
For frequency-cut, turn the control anti-
clockwise
Controls the high-frequency response of the pre-amplifier.
Allows the on-board limiter to be defeated if desired. With
the switch in the out position the limiter is engaged. The
limiter is automatically triggered at high-output levels
and is designed to prevent power-amp distortion at high-
output levels. When the limiter is autpmatically triggered
an LED lights up to indicate the limiter is active. It is
possible to have the limiter engaged but not have the LED
active.
The LIMITER monitors both power-amp clipping and
load so it automatically registers the cabinet-impedance and
sets itself accordingly.
Sets the overall listening level of the amplifier.
Switches the on-board horn either on or off.
XLR socket for direct-injection of the amplifier signal to a
mixing-desk or additional power-amplifier. The XLR socket
provides a low-impedance output-signal.
This socket(s) should be used to connect an extension-
cabinet.
The impedance of the extension-cabinet must
not be less than 8 Ohms.
Connecting cabinets that have a
lower impedance than 8 Ohms will result in the amplifier
overheating . Continual use in this
manner may cause
permanent damage. Connecting a cabinet with an impedance of
greater than 8 Ohms will cause no damage to the amplifier but
will result in a reduced output.
Socket for connecting external tuner.
Send and return sockets are provided for connecting external
effects-units..
Laney
10
Laney
6. Lo Paramid frq:
7.Lo Paramid Level:
8. Hi Paramid frq:
9.Lo Paramid Level:
10.Treble:
11.Limiter:
12. Volume:
13.Horn switch:
14.D.I:
15.Ext Speaker
socket:
16.Tuner out:
17.FX Loop:
Richter