Lanier 5455 Operator's Manual - Bypass Copying
Bypass Copying
Copying Methods
4 - 5
Bypass Copying
Using Stack Feed Bypass
1
If Duplex mode is selected, touch the Duplex/Combine key and turn it OFF.
2
Place your original on the Document Feed Tray or on the Exposure Glass.
3
Open the Bypass Paper Tray.
•
The Bypass Tray indicator turns ON in the
display.
•
If the indicator does not turn ON, the copy
mode is set for duplex. Change the copy
mode to single side copying.
4
Adjust the Bypass Paper Guides to the width of the
copy paper.
•
Be sure to place the copy paper in the same direction as the original.
If you want to make a copy on a transparency for overhead projection (OHP), or have the need
to use special paper, letterhead, or paper other than that which is in the copier Paper Tray, you
may feed this paper into the Stack Feed Bypass Tray. See “Using Stack Feed Bypass” on page
•
Bypass does not work in the Duplex mode.
•
Bypass copying bypasses the Paper Trays and feeds copy paper from the Stack Feed
Bypass Tray.
Use the Stack Feed Bypass to feed standard paper, transparency, label stock, tracing paper,
letterhead, and other special purpose papers measuring from 8.5” x 5.5” to 11” x 17”.
•
The copier automatically detects standard paper sizes: 11" x 17", 8.5" x 11", 5.5" x
8.5".
•
If you are using non-standard size paper, you should enter the paper size. See