Lanner LEC-6040 User manual - Emc Notice
EMC Notice
This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when
the equipment is operated in a commercial environment.
This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may cause
harmful interference to radio communications. Operation
of this equipment in a residential area is likely to cause
harmful interference in which case users will be required
to correct the interference at their own expense.
Safety Guidelines
Follow these guidelines to ensure general safety:
Keep the chassis area clear and dust-free before,
•
during and after installation.
Do not wear loose clothing or jewelry that could get
•
caught in the chassis. Fasten your tie or scarf and roll
up your sleeves.
Wear safety glasses/goggles if you are working
•
under any conditions that might be hazardous to
your eyes.
Do not perform any action that creates a potential
•
hazard to people or makes the equipment unsafe.
Disconnect all power by turning off the power and
•
unplugging the power cord before installing or
removing a chassis or working near power supplies
Do not work alone if potentially hazardous
•
conditions exist.
Never assume that power is disconnected from a
•
circuit; always check the circuit.
LITHIUM BATTERY CAUTION:
Risk of explosion could occur if battery is replaced by an
incorrect type. Please dispose of used batteries according
to the recycling instructions of your country.
Installation only by a trained electrician or only by an
•
electrically trained person who knows all the applied
or related installation and device specifications..
Do not carry the handle of power supplies when
•
moving to other place.
The machine can only be used in a fixed location
•
such as labs or computer facilities.
Operating Safety
Electrical equipment generates heat. Ambient air
•
temperature may not be adequate to cool equipment to
acceptable operating temperatures without adequate
circulation. Be sure that the room in which you choose to
operate your system has adequate air circulation.
Ensure that the chassis cover is secure. The chassis design
•
allows cooling air to circulate effectively. An open chassis
permits air leaks, which may interrupt and redirect the flow
of cooling air from internal components.
Electrostatic discharge (ESD) can damage equipment and
impair electrical circuitry. ESD damage occurs when electronic
components are improperly handled and can result in complete
or intermittent failures. Be sure to follow ESD-prevention
procedures when removing and replacing components to avoid
these problems.
Wear an ESD-preventive wrist strap, ensuring that it makes
•
good skin contact. If no wrist strap is available, ground
yourself by touching the metal part of the chassis.
Periodically check the resistance value of the antistatic
•
strap, which should be between 1 and 10 megohms
(Mohms).
Version
Date (Y/M/D) Description
0.1
2014/11/07
Preliminary
0.2
2014/11/12
Added hardware setup
0.3
2014/11/21
Revised pin assignments and
specifications
1.0
2015/06/29
Official release
1.1
2015/09/09
Removed CompactFlash
Added mSATA signal to mini-
PCIe socket2