Lanpro LP-SGW2400 User Manual - page 5
www.lanpro.com
Active Products - Switches - LP-SGW2400
3.3 Ports
Port display Link station and can set each port as: speed,
flow control. Every port can choose one work mode in 7
kinds as below: 10M half-duplex, 10M full-duplex, 100M
half-duplex, 100M full-duplex, 1000M full-duplex, auto-
negotiation, disable. Default is auto-negotiation. Each port
must choose a best work mode after it is negotiated with the
corresponding object automatically.
5
Figure 4
3.4 VLANs
Can set 16 VLAN groups for 802.1q VLAN.
VLAN group setting: the port can communicate only when it
is set to the same VLAN goup, a port can belong to a multi
VLAN group, and can communicate with a multi Vlan group
at the same time.
Figure 5
3.5 Aggregation
Aggregation, also called port trunk ismostly used for the
Uplink passage redundancy, an incorrect containerTrunk
group can not span the VLAN, all the trunk members must
be in the same VLAN, otherwise Trunk function will be lost.
You cannot connect the two Trunk groups into each other,
and cannot connect two switches by two Trunk passages.
Any operation of them will make the network cycle and stop
the network.
Figure 6