1. DL manuals
  2. Lanpro
  3. Network Router
  4. LP-SW811
  5. User Manual

Lanpro LP-SW811 User Manual

Other manuals for LP-SW811: User Manual

Summary of LP-SW811

  • Page 1

    Active products - switches www.Lanpro.Com lpsw811_ug_enb01w lp-sw811 10/100m fast ethernet switch. User´s guide. Lp-sw811 10/100m fast ethernet switch. User´s guide. Copyright & trademarks specifications are subject to change without notice. Lanpro is the registered trademark of lanpro. Other brands...

  • Page 2

    Www.Lanpro.Com active products - switches - lp-sw811 10/100m fast ethernet switch - user guide table of contents 2 1.- package contents......................................................................................................3 2.- chapter 1: introduction ....................................

  • Page 3

    Www.Lanpro.Com active products - switches - lp-sw811 10/100m fast ethernet switch - user guide package contents chapter 1: introduction chapter 2: installation 1 2 3 1.1 overview of the product 1.2 features 2.1 installation the following contents should be found in your box: note: if any of the abov...

  • Page 4

    Www.Lanpro.Com active products - switches - lp-sw811 10/100m fast ethernet switch - user guide lp-sw811 10/100m fast ethernet switch power 1 2 3 4 5 6 7 8 link act lp-sw811 10/100m fast ethernet switch power 1 2 3 4 5 6 7 8 link act 1 2 3 4 5 6 7 8(uplink) 4 2.2 power on 3.1 front panel 3.2 rear pan...

  • Page 5

    Www.Lanpro.Com active products - switches - lp-sw811 10/100m fast ethernet switch - user guide 5 appendix a: specifications 5 power led: this indicator will light up when the switch powers up. If the led is not lit, please check the power adapter and connection. Link/act leds: these leds indicate li...

  • Page 6

    Www.Lanpro.Com active products - switches - lp-sw811 10/100m fast ethernet switch - user guide 6 appendix b: troubleshooting appendix c: contact information 6 7 1. The power led is not lit 2. The link/act led is not lit when a device is connected to the corresponding port make sure the ac power adap...