Lanpro LP-SW811 User Manual - page 4
www.lanpro.com
Active Products - Switches - LP-SW811 10/100M Fast Ethernet Switch - USER GUIDE
LP-SW811
10/100M Fast Ethernet Switch
Power 1
2
3
4
5
6
7
8
Link
Act
LP-SW811
10/100M Fast Ethernet Switch
Power 1
2
3
4
5
6
7
8
Link
Act
1
2
3
4
5
6
7
8(UPLINK)
4
2.2 Power on
3.1 Front Panel
3.2 Rear Panel
LED indicators
After the Switch powers up, it will be automatically initialized and the LED indicators should respond as follows:
This Chapter describes the front panel, rear panel and LED indicators of the Switch. The sketches of the front panel,
rear panel and LED indicators are very similar between LP-SW811. The following sketches are for LP-SW811.
The front panel of the LP-SW811 consists of several LED indicators.
The rear panel of the LP-SW811 consists of 8 10/100Mbps RJ45 Ports. All ports can be the Uplink port, and the “Uplink”
mark under Port 8 can be ignored.
The LED indicators include Power LED and Link/Act LEDs. The LED indicators are used for monitoring and troubleshooting
of the Switch. The following section shows the LED indicators for the Switch along with an explanation of each indicator.
Figure 3-1 LP-SW811 Switch Front Panel sketch
Figure 3-3 LP-SW811 Switch LEDs sketch
Figure 3-2 LP-SW811 Switch Rear Panel sketch
All of the Link/Act LED indicators will flash momentarily, meaning the switch is being reset.
The Power LED indicator will light up.
1
2
Chapter 3: Identifying External Components
4