Lanta Fireball Par 64S Owner's Handbook Manual - 1- Built-In Program Mode
© Lanta Lighting™ 2011. Terms Apply. All trademarks are the property of their
respective owners. E&OE. All specifications and details are correct at time of print.
Revision 1
Fireball Par64S Owner Handbook ™
Operation of the Lanta Fireball Par64S™
To select the various different modes of operation, there is a 4 button keypad and a 4
digit LED display on the rear of the product.
To begin, press the button marked “MODE”. Each press will choose one of the working
modes described below. Once the desired mode has been selected, the button marked
“ENTER” will allow the user to select a parameter that they wish to change (such as speed
etc). To choose a value of the parameter, press either the “UP” or “DOWN” buttons until
the desired setting is achieved.
Note: There is no need to have a “store” button, as this is automatically done for you.
Note: The LED display will enter power saving mode after 20 seconds after the last button
press. It will turn on again after pressing any button.
Note: When first powered on, the display will briefly show the firmware version programmed
into the memory of the controller. This is displayed as a “U” followed by the version number.
(e.g. “U3.01”)
1- Built-in PROGRAM Mode
To use the built-in program mode – a library of exciting and vibrant colour changes, keep
pressing the “MODE” button until the LED display shows “PR” followed by a 2-digit number
(e.g. PR07). The “UP” and “DOWN” buttons allow the selection of a program.
Program 01 is a static colour mode. By pressing “ENTER” the desired colour can be
selected by using the “UP” and “DOWN” buttons. There are seven static colours:-
1- Red (Red)
2-Red & Green (yellow)
3- Green (Green)
4- Green & Blue (Cyan)
5- Blue (Blue)
6- Red & Blue (Magenta)
7- Red & Green & Blue (White)
Special Effects:
(1) Press ENTER again to set the BRIGHTNESS of your chosen static colour. This is from 000
(off) to 255 (full brightness)
(2) Press ENTER again for FLASH mode. “FS00” is static through to “FS99”, the fastest flash
rate of your chosen static colour.
Program “PR02” to “PR10” are pre-programmed patterns that either colour switch or
colour fade. After selecting the desired pattern, the special effects shown in (1) and (2)
can be selected.