Lantronix 15.00.033 Product Manual - page 10
Lightwave Communications
DVI Fiberlynx
www.lightwavecom.com
November
2001
10
2.4 Connecting the User Peripherals
1.
Place the DVI Fiberlynx receiver on or near the user station.
2.
Connect the monitor to the DVI Fiberlynx Receiver. The left-most DVI
connector (DVI OUT) is the primary video connector. The DVI AUX
connector is for an (optional) auxiliary monitor. This monitor will show
identical information as the primary monitor.
DVI Fiberlynx Receiver, DVI and Fiber Optic Connectors
Note:
During initial setup, a DVI video configuration 'video record' is made using
the connection established between the CPU and the Monitor connected
to the DVI OUT on the DVI Fiberlynx Receiver unit.
3.
Connect the audio devices to the Receiver. The lower connector, marked
“MIC IN”, is for use with a microphone only. The upper connector, marked
“LINE OUT”, is for connection to powered speakers or headphones.
4.
Connect the serial device to the Receiver. The receiver’s serial port is
pinned the same as a DB9F serial port found on the CPU.
Primary DVI Video Connection
at Receiver (Desktop) end
Auxilary DVI
Video Connection