Lantronix Com Port Redirector User Manual - page 20
−
MSS, ETS, and SCS products: set the access mode to remote on
the serial port receiving the connection from the Com Port
Ser
e device
server must be correct. Consult your documentation for the pinouts of
Consult
these se
General Com Port Redirector Usage Guidelines
t Redirector:
Do not run Com Port Redirector with other software that installs a virtual
e PC.
onfiguring a UDS, CoBox, XPort, or XPress Device Server
a UDS,
er before using Com Port Redirector.
9 on the device server.
ctor will
e of
device attached to the Lantronix device server.
8.
Redirector.
ial cabling between the serial device being managed and th
your Lantronix device server.
your device server documentation for information about configuring
ttings for your device server.
Observe the following general guidelines when using Com Por
com port.
Do not run Com Port Redirector with other Comport Redirection software
on the sam
C
This section describes how to configure Com Port Redirector for use with
CoBox, XPort, or XPress device server.
Device Server Configuration
1. Assign an IP address to the device serv
2. Telnet into the configuration port 999
3. When prompted, press the Enter key.
4. Select the channel (serial port) to which the Com Port Redire
connect.
5. Set the serial settings (baud rate, parity, flow control, data bits) to thos
the serial
6. Set the port number to 10001 if using channel 1. Set the port number to
10002 if using channel 2.
7. Set the connect mode for the channel to C0.
Leave all other settings at the default settings.
4-2
Com Port Redirector™
User Guide