Part number 900-582 revision a january 2011 premierwave ™ evaluation board quick start.
Premierwave evaluation board quick start 2 copyright and trademark © 2011 lantronix. All rights reserved. No part of the contents of this book may be transmitted or reproduced in any form or by any means without the written permission of lantronix. Printed in the united states of america. Ethernet i...
Premierwave evaluation board quick start 3 table of contents copyright and trademark ____________________________________________________ 2 contacts __________________________________________________________________ 2 disclaimer and revisions ____________________________________________________ 2 re...
Introduction premierwave evaluation board quick start 4 introduction thank you for purchasing the premierwave evaluation board or development kit from lantronix. This quick start guide describes the procedures for initial connection to the premierwave device through either a network connection or se...
What you need to know premierwave evaluation board quick start 5 what you need to know hardware address you need to know the unit hardware address (also known as mac address) to identify the unit in the device installer search list. It is on the product label in the format: xx-xx-xx-xx-xx-xx, where ...
Connecting a premierwave device—network method premierwave evaluation board quick start 6 connecting a premierwave device—network method choose the desired connection method for your premierwave, and then follow the instructions in the corresponding section. You have three options for connecting to ...
Connecting a premierwave device—network method premierwave evaluation board quick start 7 5. Select the appropriate power plug adaptor for your geographical location. Insert it into the slot on the universal power supply; then plug the power supply into an outlet. 6. Connect the output plug of the p...
Connecting a premierwave device—serial method premierwave evaluation board quick start 8 connecting a premierwave device—serial method in the event that the equipment required for a network connection is not available for the initial configuration of premierwave, the serial method can be used. 1. Co...
Assigning an ip address premierwave evaluation board quick start 9 4. Select assign a specific ip address and click next . 5. Enter the ip address. The subnet mask appears automatically based on the ip address. You may change it. On a local network, you can leave the default gateway blank (all zeros...
Configure your premierwave device premierwave evaluation board quick start 10 10. Click clear status to clear the window to ping the device again. Note: if you do not receive “reply” messages, ensure the ip address assigned is valid for the particular network segment you are working with. For a wire...
