- DL manuals
- Lantronix
- Motherboard
- PremierWave
- Quick Start Manual
Lantronix PremierWave Quick Start Manual
Summary of PremierWave
Page 1
Premierwave evaluation board quick start part number 900-582 revision c july 2014.
Page 2
Intellectual property © 2014 lantronix. All rights reserved. No part of the contents of this book may be transmitted or reproduced in any form or by any means without the written permission of lantronix. Printed in the united states of america. Lantronix and premierwave are registered trademarks of ...
Page 3
Revision history date rev. Comments january 2011 a initial document. July 2011 b updated with webmanager information, for v7.2 release. July 2014 c updated to include the premierwave se1000 embedded system on module. For the latest revision of this product document, please check our online documenta...
Page 4: Table Of Contents
Table of contents intellectual property _________________________________________________________ 2 contacts __________________________________________________________________ 2 disclaimer and revisions ____________________________________________________ 2 revision history _________________________...
Page 5: Introduction
Introduction introduction thank you for purchasing the lantronix® premierwave® evaluation board or development kit. This quick start guide describes the procedures for initial connection to the premierwave device through either a network connection or serial port. This user guide can be used for the...
Page 6: What You Need to Know
What you need to know what you need to know hardware address you need to know the unit hardware address (also known as mac address) to identify the unit in the device installer search list. It is on the product label in the format: xx-xx-xx-xx-xx-xx, where the xxs are unique numbers assigned to the ...
Page 7
Connecting a premierwave device—network method connecting a premierwave device—network method choose the desired connection method for your premierwave, and then follow the instructions in the corresponding section. You have three options for connecting to premierwave: 1. Wired connection via ethern...
Page 8
Connecting a premierwave device—network method 5. Select the appropriate power plug adaptor for your geographical location. Insert it into the slot on the universal power supply; then plug the power supply into an outlet. 6. Connect the output plug of the power supply to the premierwave evaluation b...
Page 9: Installing Deviceinstaller
Connecting a premierwave device—serial method connecting a premierwave device—serial method in the event that the equipment required for a network connection is not available for the initial configuration of premierwave, the serial method can be used. 1. Connect one end of the supplied db9f/f serial...
Page 10
Assigning an ip address 4. Select assign a specific ip address and click next . 5. Enter the ip address. The subnet mask appears automatically based on the ip address. You may change it. On a local network, you can leave the default gateway blank (all zeros). 6. Click next . 7. Click assign and wait...
Page 11
Configure your premierwave device 10. Click clear status to clear the window to ping the device again. Note: if you do not receive “reply” messages, ensure the ip address assigned is valid for the particular network segment you are working with. For a wireless unit, ensure the premierwave is visible...
Page 12
Configure your premierwave device 3. Enter your user name and password and click ok . The default user name is admin and the default password is pass . 4. Use the menu on the left to navigate to the sub-pages where you can configure the device. 5. Commit any changes with the submit button, on every ...