Lantronix PremierWave Quick Start Manual - page 11
Configure Your PremierWave Device
10. Click
Clear Status
to clear the window to ping the device again.
Note:
If you do not receive “Reply” messages, ensure the IP address assigned is valid for
the particular network segment you are working with. For a wireless unit, ensure the
PremierWave is visible on the network created by the laptop or desktop PC’s wireless
card.
11. Click
Close
.
Configure Your PremierWave Device
From DeviceInstaller, it is easy to access the CLI, via the Telnet Configuration tab, or start the
Lantronix browser-based tool, Web Manager, to configure the PremierWave. For detailed
information on configuration, see the
PremierWave EN Embedded System on Module User Guide
and
PremierWave EN Embedded System on Module Command Reference
if you are using the
PremierWave EN model, or the
PremierWave SE1000 Embedded System on Module User Guide
and
PremierWave SE1000 Embedded System on Module Command Reference
if using the
PremieWave SE 1000 system on module.
For the CLI Access via Telnet Configuration
1. In DeviceInstaller, select the unit and then the
Telnet Configuration
tab.
2. Press the
Connect
icon. The Lantronix CLI shell appears.
3. If line authentication for CLI is enabled, enter your user name and password
.
The default user
name is
admin
and the default password is
PASS
.
4. Use the CLI commands to configure the device.
5. Commit any changes with the
write
command.
For the Web Manager Access
1. In DeviceInstaller, select the unit and then the
Web Configuration
tab.
2. Press the
Go
icon. The Lantronix Web Manager login window appears.
PremierWave® Evaluation Board Quick Start
11