Lantronix SecureLinx Spider Quick Start Manual - page 8
Q uick Star t Guide
SecureLinx Spider Duo
6
5. Follow the prompts to enter the unit’s IP address, subnet mask, default
gateway, and LAN interface information.
6. Press Enter, to accept the changes. The system takes about 20
seconds to complete. Press Enter once again at the prompt to display the
updated IP address.
7. Plug an Ethernet cable connected to your network into the Ethernet port.
The Link LED illuminates.
INSTALLATION AND NETWORK SETTINGS CONTINUED
[172.18.100.17 spider]> config
IP autoconfiguration (none/dhcp/bootp) [dhcp]: none
IP [172.18.100.17]:
NetMask [255.255.0.0]:
Gateway (0.0.0.0 for none) [172.18.0.1]:
LAN interface speed (auto/10/100) [auto]:
LAN interface duplex mode (auto/half/full) [auto]:
Are the entered values correct? Enter y for Yes, n for No or c to Cancel y
Configuring device ...
Welcome!
Choose a command for the following features:
-Initial IP configuration: "config".
-Reset device: "reset".
[172.18.100.17 spider]>