Lanzar VBD 1600 Owner's Manual - page 6
6
GENERAL OPERATION
• ON/OFF/ILLUMINATE
As show in Fig. 1, press the hidden wireframe to turn on the unit, the front panel’s
state will change into Fig. 2. Press /ILL button (9) shortly to control the brightness
of VFD. Press it for several seconds to turn off the unit and the state will change
into Fig. 1 again.
• MOVE THE PANEL
Press (Open) button (7) to back the control panel into the main body and make
the display panel downward as show in Fig. 3. Press it again to return to the state
of Fig. 2 and continue your operation.
• SOUND ADJUSTMENT
Press SEL button (10) shortly to select the desired adjustment mode.
The adjustment mode will change in the following order:
By pressing Volume Up button (11) or Volume Down button (12), it is possible
to adjust the desired sound quality.
• LOUDNESS
Press LOU/BND button (13) for several seconds to reinforce the bass output and
display will show "LOUD". Press it for several seconds again to release this function.
• SET THE CLOCK
Holding down the DSP button (15) until the clock is shown on the VFD display and
flashes. Then press TUNE/SKIP/TRACK button (16) to change minutes or
TUNE/SKIP/TRACK button (17) to change hours.
• SELECT MODE
Press MOD button (6) to choose the desired listening mode.
(E.g. radio mode to CD/MP3 mode)
• SUB-WOOFER
Press MOD/SW button (6) for several seconds to toggle subwoofer output.
When subwoofer on, display will show “Sub.W”. Press it again for several seconds
to release this mode.
• MUTE
Press the MUT button (3) to silence the receiver. Press it again to resume listening.
• VACUUM FLUORESCENT DISPLAY
Exhibit current frequency and activated functions on the display (8).
• EQUALIZATION
Press EQ button (1) to turn on equalization function and to select desired audio
mode. There are five kinds of mode as below:
Volume
Bass
Treble
Balance
Fader
FLAT
CLASSIC
POP
JAZZ
DSP OFF