Lapcom s series gps receiver instruction manual percul corporation.
Names of parts of gps receiver 1. Built-in gps antenna １ ２ ３ ４ ５ ６ ７ gps antenna is inside. 2. Power lamp(blue) the lamp illuminates when the power is on. 3. Status lamp(red) the lamp illuminates or flashes when receiving information from the satellite. 4. Power port insert the power connector. 5. C...
How to install gps receiver 1. Put the top side with logo horizontally toward the sky on the location where the signal from the satellite can be received well. 2. Connect to 12v power battery or 9v square type battery on the other side of the power connector, and insert the connector to the power po...
Installation for kart attach the gps receiver’s top side with logo horizontally toward the sky on the front panel by two-sided tape or hook & loop fastener. Please provide the installation bracket as per your requirement. Installation for motorbike attach the gps receiver’s top side with logo horizo...
Parameter setting of the lapcom unit set the communication speed between gps receiver and lapcom unit. 1. Verify that [ready] is displayed on the display screen. If [ready] is not displayed, press the clear key to display it. 2. Press and hold the shift key and mode key at the same time for 3 second...
7. Confirm the following parameter setting to log the driving data properly. Press and hold the clear key for 3 seconds to exit the setting. Parameter no. 3: number of segments parameter no. 4: sensor off timer parameter no. 5: speed pulse length parameter no. 7: logging start/stop condition * pleas...
Notice points cold start: the first start after purchasing the gps receiver, or the start after remaining unused for a long period. Please notice cold start will take longer time to acquire the gps satellite, like about 35 seconds. Turn on the power of the device 15-30 minutes before driviing in a o...
